3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
Left: I opened a sealed roll of a filament purchased in 2018 and I printed that rose
Right: I dried that filament in the creality dryer overnight and sent the print again
This pic was taken on 10th April. After drying the filament I put it back in storage and I forgot about it until it exploded today
That's a good way to keep filament dry, but it takes a very long time to remove moisture from filament that way. It's a lot faster to use a dryer/dehydrator before putting it in the dry box.
Thats true, and a good point.
But as long as you go straight from the original packaging to your dry box, you shouldn't have to worry much about it ever getting wet to begin with.