There is though. Iirc up to 15 digit subohm precision trimmed resistors are a thing just an uncommon and extremely expensive thing.

They are, however, absolutely thrilled that the smallest resistor package is now ~ 1x the plank length on the narrow side.

well there's certainly none in the chip aisle

This is EXACTLY how it went for me when I moved from a Physics to an Electronics Engineering degree at University.

Also, the trying to understand how the various circuits worked from the point of view of "electrons moving" was a hard to overcome early tendency (even simple things like LC circuits, for example, are only really understandable as ressonant stable states and for complex circuits you really have to go higher levels than "electrons" to be able to understand then in any reasonable amount of time).

On the upside when we got to things like how tunnel effect diodes worked, the whole thing was just obvious because of having had an introduction to Quantum Mechanics in the Physics degree. Also the general stuff about how semiconductor junctions work is a lot more easy to get if you come from Physics.

(In summary: Physics really helps in understanding HOW the various components in Electronics work, but doesn't at all help in understanding how to use them to assemble a complex structure to achieve a given objective. Curiously this also applies to Mathematics and Software Development)

Watching people repair old electronics on Youtube has opened my eyes to the realities of real-world electrical engineering. In short: it's all about tolerances.

A power supply may have a nominal voltage of 5V, but anything from 4.8 to 5.2 is a-okay. Why? Because your TTL components downstream of that can tolerate that. Components that do 5V logic can define logic zero as anything between 0 and 0.8 volts, and logic one as low as 2 volts. That's important since the whole voltage rail can fluctuate a lot when devices use more power, or draw power simultaneously. While you can slap capacitors all over the place to smooth that out, there's still peaks and dips over time.

Meanwhile, some assembly lines have figured out how to aggressively cost-reduce goods by removing whole components from some circuits. Just watch some Big Clive videos. Here, the tendency is to lean heavily into those tolerances and just run parts hot, under/over powered, or just completely outside the published spec because the real-deal can take it (for a while). After all, everything is a resistor if you give it enough voltage, an inductor if the wire's long enough, a capacitor if the board layout is a mess, and a heatsink if it's touching the case.

Astrophysicists would be happy with a 1 ohm resistor.

You're getting a 10 ohm resistor and liking it.

just get a variable resistance, aka a potentiometer, and have fun adjusting it to get that value.

I kinda wonder if there's a specific reason for that number other than just being an ass.