I tried printing something on my bambu instead of my voron since I cant get the voron working properly. Why do the outer walls do this?
this post was submitted on 29 Apr 2025
10 points (100.0% liked)
3DPrinting
17888 readers
27 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
That the default petg profile? Bump up your temperature by 10C and try again. Their PETG profile is too cold for the flow rate.
I actually lowered it to 250 and turned off the fan and it didn’t help.
Wrong way to adjust, try printing at 265 and keep the part fan on ( aux fan off).
the spool says not to exceed 250
Run a temp tower if you are worried about it, but I run all PETG at 265 on my P1S. 255 will tear like you show and print matte which means it isn't properly melted.
Here's the thing about temperature sensors, they vary.