Ask Lemmy
A Fediverse community for open-ended, thought provoking questions
Rules: (interactive)
1) Be nice and; have fun
Doxxing, trolling, sealioning, racism, and toxicity are not welcomed in AskLemmy. Remember what your mother said: if you can't say something nice, don't say anything at all. In addition, the site-wide Lemmy.world terms of service also apply here. Please familiarize yourself with them
2) All posts must end with a '?'
This is sort of like Jeopardy. Please phrase all post titles in the form of a proper question ending with ?
3) No spam
Please do not flood the community with nonsense. Actual suspected spammers will be banned on site. No astroturfing.
4) NSFW is okay, within reason
Just remember to tag posts with either a content warning or a [NSFW] tag. Overtly sexual posts are not allowed, please direct them to either [email protected] or [email protected].
NSFW comments should be restricted to posts tagged [NSFW].
5) This is not a support community.
It is not a place for 'how do I?', type questions.
If you have any questions regarding the site itself or would like to report a community, please direct them to Lemmy.world Support or email [email protected]. For other questions check our partnered communities list, or use the search function.
6) No US Politics.
Please don't post about current US Politics. If you need to do this, try [email protected] or [email protected]
Reminder: The terms of service apply here too.
Partnered Communities:
Logo design credit goes to: tubbadu
view the rest of the comments
The first steel mill I worked for, the test requirements were more of a suggestion than a rigid specification. I, a trained and skilled engineer with the capacity to make informed decisions, had to run all rejections by my boss who would tell me "it's close enough" even if it wasn't. Sometimes it bit us in the ass with warranty failures, but the warranties were probably cheaper than internal rejections (and what is brand perception worth?).
My second steel mill job, I was the one making the rejection decisions. I did the hard thing and rejected our failures but I also troubleshot them to prevent recurrence, making our product and capability better over time.
It very much matters who you buy your steel from; two mills can have vastly different performance for the same products based on how they handle these situations.
I’m curious: is this a major lawsuit waiting to happen, or is the mill somehow protected from that?
I’m picturing a situation where bad steel is provided, used by the purchaser, and later the product they put the steel in fails, causing a serious accident, death, or other severe issue. does the mill’s responsibility somehow end at warranty replacement or have they created a bigger liability for themselves?
This is indeed illegal and immoral. Example.
Elaine thomas did this, lied to her bosses, and the industry. People even considered her an expert. Reading the usdoj interviews with her, she may have just been arrogant, and kinda dumb.
Section 54 of the complaint against Elaine Thomas
A lot of companies seems to do that a lot, cut corners on the quality a little bit, push out the extra reserve capacity, etc. Then when a complaint occurs y'all quality engineers get the short end of the stick. What doesn't cost the company costs us more time, effort, mental and physical health.