3DPrinting

15651 readers

355 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: [email protected] or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

[email protected]

Trouble with warping (feddit.dk)

submitted 1 day ago* (last edited 1 day ago) by [email protected] to c/[email protected]

17 comments fedilink hide all child comments

I have some very consistent issues with warping when printing ASA/ABS, which is really annoying since I'm trying to print my voron parts. It's not warping massively, but enough to mess things up.

I print with these general settings, on a textured PEI flex-plate.

heated chamber @ 45-47C (can't go much higher)
bed temp @105C
first layer 255C, other layers 245C
fan off, unless it's an overhang >=50% or layer time is <10s. Fan maxes out @70% unless bridging.
speed 200/120 mm/s inner/outer walls
first layer 50mm/s, 80mm/s infill

I've tried both with my regular Z-offset which creates a good uniform first layer, and slightly lower to kind of push it more on to the plate (but worse looking)

I've cleaned the plate with pure IPA
I've tried glue stick
I've tried brim both skirts/mouse ears, which help but don't eliminate it. (5mm, 0.15mm space)

ABS seems to be a little easier to print than the ASA. I'm using filament from Polymaker

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 2 points 23 hours ago* (last edited 23 hours ago) (1 children)

I'll give 95C bed a try, I do have a smooth PEI bed as well so I'll try that one too. Filaments should be dry, but I'll give them another round in the dryer before trying again.

[–] [email protected] 2 points 23 hours ago

Yeah, it's counterintuitive but too high of a bed temp can cause less adhesion as it makes the first layer plastic underneath too soft. 95 to 100 should be all you need, unless you verify with an external thermocouple that your bed surface runs too cold vs the printer's thermistor.