Grippler

Haven't really used a mocha pot before, so I'm experimenting a little to find the right grind settings and ratios for my taste. Normally brew espresso on a flair classic. Went with this more modern design from bialetti because it also works on induction stoves.

Jeg har lige smidt graphene OS på min pixel 8a, og havde egentlig lidt en forventning om, at det ville virke bedre end min gamle med lineage OS, når nu telefonen kan lave fuldt verified boot, med en bruger med play services installeret og den ikke er rootet...men ak nej, det er noget værre bøvl og det fejler i sidste del af verificeringen.

Kan det overhovedet lade sig gøre uden alle mulige træls krumspring som magisk osv?

Jeg har en pakke jeg står og skal bruge ASAP, den er blevet sendt til pakkeboks og ligger nu der og hygger sig.

Jeg kan ikke åbne pakkeboksen via appen, får simpelthen ikke muligheden for at åbne den. Har fået både mail og SMS med at jeg kan afhente den i pakkeboksen.

Postnord er ikke til at komme i kontakt med, hverken mail, chat eller noget som helst.

Så de har nu reelt taget min pakke, og vil ikke udlevere den, selvom den er kommet til destinationen.

What to do??

Edit: har snakket med dem efter "kun" 5 timers ventetid...deres løsning er, at flytte pakken til nærmeste posthus (~1km væk), med 3 hverdages forsinkelse. Fuck de her inkompetente bæ-hoveder (PN, ikke den specifikke kundeservice medarbejder), det er simpelhen utroligt man kan være så sindssygt dårlig til at gøre et så simpelt job.

Is there a slicer that let's you configure sections of the model to print at a different layer height?

I often have some larger models I'm printing, and 0.3mm layers are just fine for this to speed things up, but some of the overhangs print very poorly with thick layers and require thinner layers to print well.

I recently made the switch from the marlin-based stock firmware on my anycubic kobra 2, to klipper. I didn't have issues with bed levelling or first layer on the stock firmware, but I'm having significant issues running klipper. The bed is uneven, the probed mesh shows a deviation of 0.197mm, it was the same when running stock FW+octoprint.

But it seemed to be correcting just fine for this on the stock FW. I got a consistent decent first layer across the entire bed.

With klipper, it's absolutely impossible to get it to correct for this unevenness. Half the bed will get perfect first layer, but then the second half is either way too squished or hardly connecting to the bed. And it's causing further issues as it's also hitting the print when moving, despite having Z-hop of 0.3mm for travel moves.

What the hell is going on? How do I fix this?

I have this incredibly loud noise coming from my Y-axis. It doesn't affect print quality, but it is horrible to listen to and really loud. It is present when the Y-axis moves at ~100mm/s and gets worse/louder as speed increases.

How can I mitigate this? There doesn't seem to be any mechanical issues when I move the bed by hand, it is smooth and easy to move.