So that's why a 2 systems were getting crappy speeds. Yes, 2. It had been used only to split a single drop from another switch between two systems.
New drop, happy clients.
Some stuff here is museum material.
this post was submitted on 20 Jun 2025
1 points (100.0% liked)
Sysadmin
9976 readers
2 users here now
A community dedicated to the profession of IT Systems Administration
No generic Lemmy issue posts please! Posts about Lemmy belong in one of these communities:
[email protected]
[email protected]
[email protected]
[email protected]
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
What type of cable did you use? Water could have seeped into which cause a bunch of weird issue because the resistance on the wires goes all wonky. I’m not sure if you have access to a cable certified like a Fluke, but if you do I would use that to test and it will most likely tell you your issue. I highly doubt it’s a grounding issue because you’d issues like that in large buildings where the power is on different phases or technical power.