So that's why a 2 systems were getting crappy speeds. Yes, 2. It had been used only to split a single drop from another switch between two systems.
New drop, happy clients.
Some stuff here is museum material.
this post was submitted on 20 Jun 2025
1 points (100.0% liked)
Sysadmin
9976 readers
2 users here now
A community dedicated to the profession of IT Systems Administration
No generic Lemmy issue posts please! Posts about Lemmy belong in one of these communities:
[email protected]
[email protected]
[email protected]
[email protected]
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
This one must be about 15 at least. Pre-dates me and I've been there for 13. Still functional so I'm at loathe to just sling it. Not fond of doing drops in such wonderful weather, in a building that is basically a dusty hot tin can. Wanted to do it properly though.
Just happy that on this side it's my direct employer and only one site. I'll have to do some more digging - I'm certain we have kit around even more legacy than this. The CNC lathe PC is y2k compliant....
At least the lathe isn't running punch tape.
Don't upgrade or mess with the control. Disconnect from the network if it's on it. It should have RS-232. Throw a Pi or other SBC that does serial and a 12V level shifter; use that to feed it programs.
Also, make an image of the hard drive if it has one and start looking for a spare drive on ebay.
I've got it covered :) - whole duplicate set of hardware & drive image. Recapped the board last year & replaced PSU too.
I won't touch the DOS software it uses to actually run the plant, the lads can have at that.
That 3com hub was new in the late 90's