callcc

cross-posted from: https://lemmy.world/post/21641314

I'm designing a case for a dew-point ventilator controller to be 3d printed. The controller is implemented using arduino on an esp32. The project is based off of the code and HW implementation by Make Magazine Germany: https://github.com/MakeMagazinDE/Taupunktluefter. When starting out I was thinking this would be an easy project but it turned out that especially the lid with its lip and groove design and the parts fixations were not that easy. I'm excited to finally print it.

The file is parametric to some extent and the main footprint is based off of a master sketch. Many parts were imported as step files from grabcad. I used FreeCAD 1.0-rc1 which works like a charm for many things. Next thing I would like to do is to use the new assembly workbench. What do you think?

Manual "Exploded view",

Opaque view.

EDIT: I didn't mention the most important part. The device switches on a ventilator when the absolute moisture content outside is lower than inside a a certain room. This results in drying of the room that you ventilate like a basement with moisture issues. The dew-point acts as a proxy for measuring absolute moisture content.

I'm designing a case for a dew-point ventilator controller to be 3d printed. The controller is implemented using arduino on an esp32. The project is based off of the code and HW implementation by Make Magazine Germany: https://github.com/MakeMagazinDE/Taupunktluefter. When starting out I was thinking this would be an easy project but it turned out that especially the lid with its lip and groove design and the parts fixations were not that easy. I'm excited to finally print it.

The file is parametric to some extent and the main footprint is based off of a master sketch. Many parts were imported as step files from grabcad. I used FreeCAD 1.0-rc1 which works like a charm for many things. Next thing I would like to do is to use the new assembly workbench. What do you think?

Manual "Exploded view",

Opaque view.

Who can suggest an ethical SMTP provider for low volume transactional mail? I'm willing to pay up to 2€/month for a few hundred mails per month.

Has anyone thought about printing narrower lines in order to get sharper corners? Once Linear advance or Pressure advance is activated, you don't get bulging corners anymore... but can we do better?

Has this been implemented anywhere yet? Does it have a name?

Hey, I've recently designed a Poster about the FHS since I often forget where I should place or find things. Do you have any feedback how to make it better?

Edit: updated with new version

Hey, I've recently designed a Poster about the FHS since I often forget where I should place or find things. Do you have any feedback how to make it better?

I updated the poster: https://whimsical.com/fhs-L6iL5t8kBtCFzAQywZyP4X use the link to see online.

Dark mode

Old version

Hey, I've recently designed a Poster about the FHS since I often forget where I should place or find things. Do you have any feedback how to make it better?

Edit: Put up new version

Dark mode

The animated gif shows how it changes throughout the seasons. Found in the Wikipedia article on athmospheric circulation.