I have got though these at reasonable speed on my mountain bike (when I was younger), with a very little bit of practice, riding through these is not hard.
No idea about wheel chairs though.
Kia ora and welcome to !newzealand, a place to share and discuss anything about Aotearoa in general
Rules:
FAQ ~ NZ Community List ~ Join Matrix chatroom
Banner image by Bernard Spragg
Got an idea for next month's banner?
I have got though these at reasonable speed on my mountain bike (when I was younger), with a very little bit of practice, riding through these is not hard.
No idea about wheel chairs though.
that looks like only kids would fit through
I've seen these around a bit. I think the idea is you walk through the side while pushing your bike through the middle. But you can ride through if you've had a bit of practice.
They want to keep out motorbikes, though, so they need to be pretty skinny.
Honestly coming from a place where even normal banana bars are being removed from path entrances, I think "they want to keep out motorbikes" is an incredibly lazy reason to have such a terrible and inaccessible design. Police enforcement is the appropriate way to deal with rare cases where someone takes their motorbike onto a clearly illegal path.
As a general guiding principle, even if we ignore the accessibility issues for wheelchairs, fat pedestrians, or more unusual types of bicycles, if your intended design involves expecting cyclists to get off their bike, that is a horrible design. Bike infrastructure should never expect a cyclist to dismount any more than car infrastructure should expect a driver to get out and push.
I guess fuck prams right
Once you've had a bit of experience pushing prams something like this isn't an issue. They are pretty common around the place. They are needed because there are idiot motor bike riders that drive at speed on the walking/cycling tracks.
How does a wheelchair or mobility scooter get through there?
That's a very good question. How do they normally get through the two hooped bar type ones?
These ones? You just weave through them.
I cant figure out what they intend this to do.
It's a very common design on shared walking/cycleways. A bike will fit through the middle, they are pretty skinny. And the one in the OP isn't finished, then will fence up to the sides so you have to go through it.
they are pretty skinny
The bit I was worried about is that it looks roughly the right height that the handlebars might hit the narrower top part.
Supposedly it's to keep motorbikes out.
But when your design also forces bikes to be lifted up, cuts out wheelchairs and even fat people...it's astonishing to me that any government department could think this was OK.
Motorbikes will 100% go round via that patch of dirt next to it.
~~I reckon (could be way wrong) that you could get a bicycle through by turning the handlebars 90 degrees in either direction so they slip through the thin bit and the bit at the bottom is wider so the wheel could go through as long as you lift it and roll the bike on its back wheel. Thats still really rubbish if that’s the design tho.~~ edit: nevermind, I was looking at it wrong. I don’t think that works.
I doubt a wheelchair is getting through there anyway anyhow.
Apparently it's not finished yet and they might end up fencing it off to prevent going around in the dirt.
If it's tp keep motorbikes out then it has failed anyway because it stops at the edge of the path, and leaves plenty of room to drive a motorbike around.
They haven't finished. It will be fenced to the edges.