3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
Yes and no; you've got a lot of engineering variables here.
Can you go physically faster in the X/Y, if limited by your volumetric flow already? Yes.
Can you go physically faster in X/Y and maintain the same quality with the current machine setup? It depends on your setup.
If you're not limited by volumetric flow of the hot end already, then you could theoretically go a lot faster. If your setup isn't rigid and able to maintain those speeds, you'll end up with garbage.
BUT NONE OF THAT MATTERS
If you think you're having heat creep - the first thing to check is the fans.
Next thing to check is that you ACTUALLY have the hot end built correctly. The stock hot end is known for pushing that PTFE tubing up, melting filament, and forming a plug between the end of the PTFE tubing and the nozzle's back face.
Additionally, 0.2mm nozzles are a BITCH AND A HALF. Get into Resin if you need better quality than a 0.4mm can provide you. Or hire it out.
You're trying to solve the wrong problem here. You don't try and go faster because something is broken. You go faster when everything is working PERFECTLY.
If you are stubborn and still want to use 0.2mm nozzles -- A: Don't own pets. B: Buy high quality filament. C: install wipers along the filament path. D: Get a good air filtration system for the area the 3D printer lives in. E: Buy high quality nozzles that you can be assured are actually 0.2mm
Since I'm curious (and just a 0.4mm scrub) I'm assuming pet hair is enough to block the nozzle?
Not just pet hair, but pet dander. Pets in general just add a bunch of stuff to the air that likes to land on top of uncovered rolls of filament; I run a repair shop for 3D printers, and after some surveying, I've found that people with pets experience clogs much more often.
0.2mm nozzles are like 25% of the area that a 0.4 has. That means every, little, potential bit of problem can, and WILL clog the nozzle.
Additionally, the 0.2mm nozzles are so tiny, there's not likely a good way to clean them, as most needles are 0.3mm or larger.
Yeah that makes sense.
I guess I've avoided that since I printed and made a thing that wipes the filament as it goes into the printer, I suppose.
Those are surprisingly effective to be quite honest. You never know what kinds of systems people have though, so you gotta kinda cover it all.
They really need to stop selling Ender 3s, 3 pro, 3 v2, and other 'prior generation' Enders. The 3v3 is the one to get now, and doesn't have near the learning curve of the old ones.
People should just stop buying enders.