Mechanic Advice

431 readers

2 users here now

This community is for getting help with vehicle or other mechanical problems.

Remember, there are no stupid questions, we want everyone to feel welcome. If you don't want to answer a question that you think is silly, then just move on and keep it to yourself.

Rules:

Don't be a dick

That is all.

founded 2 years ago

MODERATORS

[email protected]

[Updated] Hydraulic lifters ticking in '95 Mazda 626 (drive.proton.me)

submitted 3 days ago* (last edited 3 days ago) by [email protected] to c/[email protected]

8 comments fedilink hide all child comments

It's a 4-cyl I4 petrol engine ('95 Mazda 626) with a ticking noise that matches with revs. I've had it for a while and it seems to be getting louder as time goes on. It doesn't go away even after longer drives.

The workshop I've used previously haven't highlighted it when I had the car in for an inspection, but after a recent incident it seems like they're rather incompetent unfortunately so I'd like some advice on this!

Thanks :)

#update x1

Spoke to the shop again and fished a bit for info. Guy at the desk re-confirmed that the gaiter was busted when I went there, and got rather apologetic when I pointed out that it wasn't.

They claim that they did notice the lifter tick but said that "it's common for older cars but you don't need to worry about it, and it's a lot of work to fix it", hence why they didn't point it out.

I'll probably postpone looking into this fully until after the road trip.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 0 points 3 days ago (1 children)

Almost anything on a car is feasible to diy imo, depending on time and tools

Bending frames straight and such might not be, but anything that just needs bolts is definitely possible.

[–] [email protected] 0 points 3 days ago* (last edited 3 days ago)

Almost anything on a car is feasible to diy imo, depending on time and tools

Oh for sure, just different amounts of scary. Seems like getting at the lifters requires partially dismounting the timing belt & lifting the cam which isn't something I've done before and requires a special tool (?) to tension the belt when reassembling.