this post was submitted on 21 Aug 2024
1 points (100.0% liked)

TechTakes

1432 readers
16 users here now

Big brain tech dude got yet another clueless take over at HackerNews etc? Here's the place to vent. Orange site, VC foolishness, all welcome.

This is not debate club. Unless it’s amusing debate.

For actually-good tech, you want our NotAwfulTech community

founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 0 points 3 months ago* (last edited 3 months ago) (2 children)

explosive is something like 20$/kg, rocket propellant (if used) would be somewhere in the same ballpark. it's cruise missile so another big cost will be small jet engine, electronics are a bulk of the cost, yeah. electronics are also what is responsible for bunch of new capabilities. new seekers? TERCOM (not on sea but yknow), maybe datalink? camera to feed image back to operator? good inertial guidance can get pricey. harden it all against jamming and EMP, keep all pieces non-chinese and assembled in usa, keep paper trail and things get expensive. and it all needs software too

for 155mm artillery shell something like third of the cost is fuze, with second most expensive component being casing (30kg-ish piece of steel rather precisely machined on lathe and heat treated in specific way)

[–] [email protected] 0 points 3 months ago

especially in case of antiship missiles (and bunker busters) casing is single piece (or few-piece, welded) of forged low alloy steel that weights a fuckton and has to be reasonably strong. it's not just a particularly violent crafts class project that is bits of steel held up by epoxy, like what you can get away with in anti-air missile

[–] [email protected] 0 points 3 months ago

paper trail is a real issue. there was a huge noise few months ago about some small part of a pump (a gasket or something) from honeywell that went into F-35, that was found out to be made in china. they had to find alternatives asap