FreeCAD

854 readers

3 users here now

Your own 3D parametric modeler.

www.freecadweb.org

FreeCAD is an open-source parametric 3D modeler made primarily to design real-life objects of any size. Parametric modeling allows you to easily modify your design by going back into your model history and changing its parameters.

founded 2 years ago

MODERATORS

[email protected]

How would you make this tray? (lemmy.world)

submitted 3 months ago by [email protected] to c/[email protected]

13 comments fedilink hide all child comments

I'm new to freecad, so far I made it this way :

Sketch a rectangle for the top surface, pad it, add filets for the corners. Then select to bottom face, make a new sketch, another rectangle, then a datum plane 40mm below, sketch another smaller rectangle, and make a loft between the two to create the bottom of the tray.

Now for the hole I made a rectangle on the top face and made a pocket with an angle.

Downside of this, the thickness of the walls is not equal. Ideally I'd like a 1.5mm thickness everywhere. And I'm not really sure how to proceed to make the separators inside the tray.

What is the most efficient way to do it? thanks

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 3 months ago (1 children)

Thanks for these tips and provisos - they are true and important. ... How would you do the divider?

[–] [email protected] 2 points 3 months ago

In this case as a loft. Not say that's necessarily the right way to do it, but that's how I'd do it. See my other comment on the matter here.