this post was submitted on 02 Apr 2024
57 points (100.0% liked)
196
16484 readers
1553 users here now
Be sure to follow the rule before you head out.
Rule: You must post before you leave.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Now I think you should test if averages hold consistent between same sided die from different manufacturers. I think another poster is right that the shape matters, so if the die from the same caster are molded roughly the same, then they’ll present with similar averages.