3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
Got an anycubic resin printer and I'm using their high speed resin (because it was bundled for free), and i tried to send a file using the high speed setting.
After the print it was seemed to be ok, then after i left in a bath of ethanol (IPA can't be found in stores in my country) i got all those holes.
What's the problem?
A slicer problem? The ethanol bath? The high speed resin that's not good?
Ethanol should be fine to use as far as I know. Do the holes go all the way through? If so your screen might have dead spots. You can visually inspect the screen by setting it to do a test exposure without the resin tank on it to check. Also obviously check that your tank doesn't have any failed print bits stick to the sheet.
visual inspection of test exposure is ok, and then the vat is brand new so the sheet was immaculate
Is this the first print you've done with it? Have you done any exposure calibration with this resin?
first print with the printer and first print with resin in my life
The manual didn't mention the exposure calibration at all...
It's probably under exposed then. Something like this and this will help you tune your slicer settings. You might need to play with other settings if you have other issues, but most of the time the exposure settings will be the problem with new resins.
Here is an alternative Piped link(s):
this
this
Piped is a privacy-respecting open-source alternative frontend to YouTube.
I'm open-source; check me out at GitHub.