I have an inspection scope camera that I'm attempting to repair. It's one with a camera on the end of a flexible rod to see into tight spaces. The pins that lead to the camera came out of the connector. I tried looking for teardowns or even replacement parts, but found nothing.
Two pins are still inserted, but I'm not confident they are in the right places. I want to get it working without the risk of frying everything. I've done my best to find where each pin goes, but there's not enough info for me figure it out on my own. The camera rod also includes an LED for light.
Here's a photo of the connector as it is:
And here is the socket with it's pins labeled (the labels correspond to the testing pads and not to the socket pins):
Here's a zoomed out pic if it's of any use:
I have a multimeter, so I can do any testing you can suggest. Unfortunately, I was not able to disassemble the camera to trace any wires.
The second connector pin from the bottom is connected to what's almost certainly a ground pour, and this is in line with the through hole labels together with your diagram. This is your black wire.
I would bet money on the rest of the labels (and your diagram) being correct too, so red wire goes to middle connector pin.
If you're fairly certain that blue is in its correct location then we're done: green goes to bottom pin. If you are not, we can take a closer look.
From the top down, that would be
Your order is correct!
With the help of the other comment suggesting to measure the voltage of VCC, I was able to verify all the pins were working.
Good job