this post was submitted on 15 Aug 2024
729 points (96.3% liked)

memes

10327 readers
1680 users here now

Community rules

1. Be civilNo trolling, bigotry or other insulting / annoying behaviour

2. No politicsThis is non-politics community. For political memes please go to [email protected]

3. No recent repostsCheck for reposts when posting a meme, you can only repost after 1 month

4. No botsNo bots without the express approval of the mods or the admins

5. No Spam/AdsNo advertisements or spam. This is an instance rule and the only way to live.

Sister communities

founded 1 year ago
MODERATORS
 
you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 10 points 3 months ago (1 children)

You're overthinking it. As long as a cast-iron pan isn't nearly rusted through or cracked in half, it's fine. Get a cheap Lodge, get an expensive one, get an old one at a yard sale -- doesn't matter. If the surface is rusty or something, just put it through an oven self-cleaning cycle, sand it down to the state shown in the meme, and re-season.

[–] [email protected] 1 points 3 months ago (2 children)

I've got a couple of dutch ovens but I can't get all the rust off, plus they rust over before I can get them oiled.
Any idea what I should do?

[–] [email protected] 1 points 3 months ago* (last edited 3 months ago)

Clean and strip seasoning with yellow cap oven cleaner(lye). If any rust remains, use a vinegar bath and scrubbing until it comes off. When you use the vinegar and get all the rust off do not let air dry, wipe dry then heat on stove until liquid evaporates. Reseason.

[–] [email protected] 3 points 3 months ago* (last edited 3 months ago) (1 children)

(Note: my previous comment mentioned only the sanding method, but I researched this reply a bit and now I think the chemical soak method is probably the better first try if a "normal" cleaning with a kitchen scrubbie or whatever isn't sufficient.)

Soak the entire pan in acid (vinegar, pool cleaner, acidic drain cleaner -- whatever) and then scrub it with a stiff-bristled brush. Make sure every part is completely submerged, handle and all (edit: wait, you said "dutch oven" -- if it's got a wire bail handle, remove that first), 'cause otherwise it can eat away at the pan at the point where the liquid meets the air. The stronger the acid you use, the quicker it'll work but the more you'll have to watch it because it'll start eating away at the metal once it finishes off the rust. Wear safety goggles and gloves, BTW. Alternatively, if the prospect of acid sounds sketchy, apparently Evapo-Rust is safe for cookware, so that's neat.

Otherwise, if you want to keep trying to remove the rust mechanically, basically try harder and with stronger abrasives. That's up to and including sandpaper, if necessary.

If the pan is pitted, either use the soaking method to get rid of the rust and just deal with cooking on the uneven surface until the seasoning builds up enough to get it out, or consider resorting to power tools (palm sander, die grinder with abrasive disc, angle grinder with flap disc, etc.) since you'll have to remove a lot of material to get the surface smooth and flat again.


In any case, once all the rust is gone, wash it with soap and water, dry it off, and season it immediately, before any new rust has a chance to start forming.

[–] [email protected] 1 points 3 months ago

Ooh. I'm saving this post for my next attempt, thank you.