Buildapc

3843 readers

15 users here now

founded 2 years ago

MODERATORS

[email protected]

Will I need to overclock RAM again? (reddthat.com)

submitted 2 months ago by [email protected] to c/[email protected]

16 comments fedilink hide all child comments

I'm saving up to get a 5700X3D around Christmas, upgrading from a 5600G, but I want to make sure I prepare properly before I do the swap.

The RAM I bought couldn't match the C18 @ 4000 M/Ts advertised and still remain stable, but I managed to manually overclock to C16 @ 3666. Should I drop to JDEC specs before I upgrade, or is it a non-issue?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 3 points 2 months ago

I'd definitely take the opportunity to make sure the BIOS is up to date (just to be sure you're running one that supports the newer CPU), or just default everything if you're already on the current version before pulling the 5600G and dropping the new one in. Then after you've confirmed the board recognizes the 5700X3D it's just a matter of changing your settings back and dialing in the memory timings.

I know it's tedious, and probably not strictly necessary, but I figure it's better to start off with a clean slate whenever you swap out a CPU or reconfigure your memory, just so something you didn't think about doesn't come back to bite you later on.

I usually just go through all the BIOS screens where I've made changes and take photos with my phone, then use those as cheat sheets to refer back to.