me_irl

That sounds familiar. My official job is more system administration, but networking is my one true love.... At least in terms of work and interests.

Ubiquiti makes pretty good wifi gear. If I'm not mistaken you'll need a controller running 24/7 to ensure that roaming and stuff works, but IMO, that should always be the case. When I'm doubt, there's always the cloud key.

Ubiquiti wireless supports VLANs, so you should be good there, if it's just going to be another SSID on your WiFi. I help run an ubiquiti network at home, we have two main LANs. My network is comprised mainly of Cisco stuff, but I'm using a sonicwall for my gateway, the other network here is entirely ubiquiti, UDM Pro, unifi PoE switches, unifi access points (about 4 right now, mostly for speed/density, though that network only has about 30 devices on it at any given time). The UDM acts as the network controller/manager. I don't love it because the routing is not where I'd like it to be (in terms of features and capability). Prime example is that I've been pushing into L3 switching and for that net we got an enterprise 48 PoE, which can do 2.5G with PoE+ on all ports, and has a slew of additional features including L3 switching. On my side I have a Cisco catalyst 4948, which is connected to the enterprise 48 on a 10G link, I wanted to use the 10G link for device to device routing. On the Cisco, everything worked like clockwork. On the ubiquiti side, you can define routes, but they're only added to the controller, which only adds them to the gateway. So traffic from my net to the ubiquiti net goes from station to switch to switch to station, and return traffic from the ubiquiti side goes from station to switch to the UDM, then to my switch, to the target station. You can manually add the routes to the enterprise 48 by cli/SSH, but as soon as the unit restarts, the config is replaced with the current config on the controller (which doesn't include the routing information).

I did it this way because my homelab, which everyone uses in some way or another, is hanging off my 4948 on a VLAN with L3 switching. I want to avoid the overhead of having it go through the extra devices and the bandwidth limits of going straight from my gateway to the ubiquiti gateway, and the enterprise 48 just won't do it. On the control panel there's no way to set what routes should be installed on which devices, so you're kind of up a creek without a paddle.

I like ubiquiti, but for anything more advanced than all VLANs being handled by the gateway directly, I wouldn't recommend it. Since most home users only need VLANs to go to the gateway at most, it's my go to recommendation for home users. It's inexpensive (relatively speaking) and it's fairly easy to manage, all while being quite good at what most users need.

If I were to do it again, I'd skip the enterprise 48. It was much more expensive than the "pro" line, which would have been adequate (no 2.5G on the pro), or even the basic 48 PoE, which only has layer 2 (VLANs). I specifically bought the enterprise so it could do this and simply put, it doesn't. I can force it to work, but I have to do the routes every time the unit restarts. It's a huge pain.

If you're only going to use ubiquiti for wifi though, have at it. It's quite good. A bit basic IMO, but I'm used to Cisco aeronet, which is above most people's heads with the options you can set. Ubiquiti is a good balance.