Ask Electronics

3315 readers

1 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 1 year ago

MODERATORS

[email protected]

Temporary pull-up during boot (ESP-01) (lemmy.world)

submitted 11 months ago by [email protected] to c/[email protected]

3 comments fedilink hide all child comments

Hi everyone!

I'm trying to control a "dumb" led light strip segment with an ESP-01S. This is fairly low current, the strip will pull 150mA-200mA max (depends on... artistic? needs).

I have two NPN transistors (2N2222), one to control the 12V supply to the white "channel" and the other the red+blue (don't need the green).

I had to pull-down the gates as I had some flickering, and it works perfectly if I manually connect the GPIOs after the ESP-01S boots.

The ESP will boot if I have the RX pin (GPIO03) pulled down on boot, but not if I pull down any of the others.

I'm not smart enough to come up with a way to have that extra pin I need to be high only during boot, while the gate it's attached to needs to be pulled down...

Any thought, other than getting something with more IO pins?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 0 points 11 months ago (1 children)

Would a circuit like this power-on reset circuit work for your application?

[–] [email protected] 0 points 11 months ago (1 children)

Im sorry, noob here. I don't know what the voltage at the reset pin would be when the capacitor is discharged, my first guess would be 0v but the answers there say it's the reverse - VCC at power on, then goes to gnd as it charges.

If that's the case, I think it's exactly what I need.

I'll test it out later today (and I'll go read more about how this capacitor+resistance circuit works...).

[–] [email protected] 1 points 11 months ago

As you said before power on capacitor is discharged. Right after power on capacitor is still discharged, so voltage on capacitor is zero, so reset pin has Vcc. With time capacitor gets charges and voltage across capacitor increases and reset voltage becomes closer and closer to ground, until it is ground. But it is important to consider what happens at power down too. At power down capacitor is charged. If power source becomes high impedance at power down, then reset pin will probably go down to zero in time but may take a bit time depending on what source exactly does. But if power source is connected to zero at power down reset pin will observe minus vcc and slowly go up to 0. If reset pin is sensitive it may be a good idea to protect it with a diode.